 |
 |
shows the sediment accumulated in the filter bowl |
shows the sediment being flushed out of the filter bowl when the purge valve is opened |
|
FEATURES:
- Easily installed on the discharge or suction side of pump -
see installation section below
- Uses centrifugal force to spin out sediment
- Sediment collects on the outside of screen, making it easy to clean
- Clear polycarbonate housing permits instant visual inspection
- Includes purge valve for quick one step flushing of sediment
- Polyester screen is easily cleaned with a soft brush if needed
- Prolongs the life of water purification filters and equipment
- Filter body is molded PVC with slip fit ports (solvent weld
to standard 1 1/2” rigid PVC pipe or fittings)
- Includes 2 bushings for 1 1/4”, 1” or 3/4” female pipe thread -
see installation section below
- UV stabilized, weather resistant materials used for long service life
- Filter cover only requires hand tightening - no tools needed
SPECIFICATIONS:
- Flow rates from 10 -50 G.P.M.
- Maximum operating pressure 150 P.S.I. at 73 degrees F (23 degrees C)
- Maximum water temperature 100 degrees F (38 degrees C) at 40
P.S.I.
- Includes 100 mesh screen with other sizes available
INSTALLATION:
- The VU-FLOW filter should be installed between the pump and
pressure tank so that system pressure will back wash the screen when the purge valve is opened.
- It can be installed between a jet pump and the foot valve -
BUT: THE FILTER MUST KEPT CLEAN SO THAT WATER FLOW TO THE PUMP IS NEVER BLOCKED, THIS CAN BURN OUT THE PUMP!
- The inlet and outlet ports are 1 1/2” slip fit (PVC solvent weld) to accept standard rigid PVC pipe.
- Bushings with 1 1/4”, 1” or 3/4” female pipe thread can be glued in - PLEASE INDICATE YOUR SIZE PREFERENCE IN THE CUSTOMER NOTES WINDOW AT THE BOTTOM OF THE ORDER FORM
|
|