Oasis WP2-1 Shallow Well Hand Pump

HAS A GLUED TOGETHER BODY

NOTE: IF YOU WANT A DIFFERENT HANDLE ORIENTATION THAN SHOWN IN THE PHOTO JUST SEND ME AN This email address is being protected from spambots. You need JavaScript enabled to view it. DESCRIBING THE DESIRED HANDLE POSITION

NEW OPTION: If you will not be pressurizing a tank or pumping water overhead, this pump can be assembled with the top cap attached with 2 screws instead of glued on. This allows the pump to be taken apart for repair or cleaning (important if you pump water from a lake or river etc. where debris can be sucked into the pump) If you wish to have the top cap attached with screws just send me an This email address is being protected from spambots. You need JavaScript enabled to view it. to let me know.

An ideal alternative to a cast iron pump.

• Made in the USA of ABS plastic with stainless steel pump rod and fasteners, the Oasis Pump is light weight, will not rust or corrode and is virtually unbreakable.
• Tests show no wear on the cylinder or plunger cup after millions of strokes.
• The Polyurethane molded cup will not wear, distort, dry out, is bacterial inert, resistant to rot, mildew and corrosion.
• The closed design helps prevent contaminants from entering a well.
• Includes adapter and elbow so a hose can be attached to pump water to another location and overhead.
• Developes 20 psi of discharge pressure which makes it good for filling overhead tanks in gravity water systems.
• The base mount allows the pump to be attached any horizontal surface i.e.. counter top using 1/4" fasteners (4 required). 1 1/4" water pipe goes from the bottom of the unit to a lake, river, cistern or well.
• It also can be screwed directly onto a 1 1/4'' or 2" pipe for a drive point (sand point) well - a 1 1/4" to 2" reducer bushing is included.
• It can be attached to a larger well casing using a platform to which the base mount is bolted - a 1 1/4" water pipe then goes down the well.
• NOTE -  this pump does not drain by lifting the handle all the way up.

SPECIFICATIONS:

• Height: 18" (45 cm)
• Base Diameter: 7" (17.5 cm)
• Cylinder I.D.:3" (7.5 cm)
• Weight: 3 lbs. (1.4 kg)
• Discharge Port: 1 1/4" female pipe thread with vermin screen and elbow with 1 1/4" female pipe thread
• Suction Port: 1 1/4" female pipe thread, or 2" with reducer bushing removed
• Capacity: 5 G.M. (23 L.P.M.) at 50 strokes per minute
• Maximum Suction Lift: 22 ft.(7 meters) - this distance decreases with altitude